Guidelines :

1. Use the entire 2×2 foot square sheet metal piece (no pieces left over).
2. Sculpture must stand on three points (planar edge counts as one point).
3. Volume of form must be open (no completely closed forms).
4. Use three lines minimum, max 1 length (10 ft.) 1/4” rod.
5. Use both welding and minimum of three pop-rivets.
6. Include minimum of three curves (lines, planar, or edges).
7. Surface finishing: torch colouring, sanding, grinding, sandblasting, etc. (no paint)

Check out the full story on my Metal Assemblage page!